當前位置: 主頁 > 直升機 > 直升機資料 >

旋翼機飛行手冊 ROTORCRAFT FLYING HANDBOOK

時間：2011-04-05 11:32來源：藍天飛行翻譯 作者：航空 點擊：次

To view this page ensure that Adobe Flash Player version 9.0.124 or greater is installed.

COLLECTIVE PITCH CONTROL—The control for changing the pitch of all the rotor blades in the main rotor system equally and simultaneously and, consequently, the amount of lift or thrust being generated.
CONING—See blade coning.
CORIOLIS EFFECT—The tendency of a rotor blade to increase or decrease its velocity in its plane of rotation when the center of mass moves closer or further from the axis of rotation.
CYCLIC FEATHERING—The mechanical change of the angle of incidence, or pitch, of individual rotor blades independently of other blades in the system.
CYCLIC PITCH CONTROL—The control for changing the pitch of each rotor blade individually as it rotates through one cycle to govern the tilt of the rotor disc and, consequently, the direction and velocity of horizontal movement.
DELTA HINGE—A flapping hinge with a skewed axis so that the flapping motion introduces a component of feathering that would result in a restoring force in the flap-wise direction.
DENSITY ALTITUDE—Pressure altitude corrected for nonstandard temperature variations.
DEVIATION—A compass error caused by magnetic disturbances from the electrical and metal components in the aircraft. The correction for this error is displayed on a compass correction card place near the magnetic compass of the aircraft.
DIRECT CONTROL—The ability to maneuver a rotorcraft by tilting the rotor disc and changing the pitch of the rotor blades.
DIRECT SHAFT TURBINE—A shaft turbine engine in which the compressor and power section are mounted on a common driveshaft.

DISC AREA—The area swept by the blades of the rotor. It is a circle with its center at the hub and has a radius of one blade length.
DISC LOADING—The total helicopter weight divided by the rotor disc area.
DISSYMMETRY OF LIFT—The unequal lift across the rotor disc resulting from the difference in the velocity of air over the advancing blade half and retreating blade half of the rotor disc area.
DRAG—An aerodynamic force on a body acting parallel and opposite to relative wind.
DUAL ROTOR—A rotor system utilizing two main rotors.
DYNAMIC ROLLOVER—The tendency of a helicopter to continue rolling when the critical angle is exceeded, if one gear is on the ground, and the helicopter is pivoting around that point.
FEATHERING—The action that changes the pitch angle of the rotor blades by rotating them around their feathering (spanwise) axis.
FEATHERING AXIS—The axis about which the pitch angle of a rotor blade is varied. Sometimes referred to as the spanwise axis.
FEEDBACK—The transmittal of forces, which are initiated by aerodynamic action on rotor blades, to the cockpit controls.
FLAPPING HINGE—The hinge that permits the rotor blade to flap and thus balance the lift generated by the advancing and retreating blades.
FLAPPING—The vertical movement of a blade about a flapping hinge.

直升機翻譯 m.ajkitchenandbath.com
本文鏈接地址：旋翼機飛行手冊 ROTORCRAFT FLYING HANDBOOK